![]() There is no timeframe for dynamic link aggregation in CRS switch-chip yet. Subject: Re: IEEE 802.3ad Dynamic link aggregation in CRS226? ![]() Well apparently SOME LAG is implemented in Hardware, here is some of a recent email I got from supportįrom: MikroTik support [ Thursday, Novem12:20 AM ![]() Currently there is no written conformation, when HW based LAG will be available even in the CRS series, if it will be available at all.Īnd because of that, there is NO WAY, that the populated MIPS-BE based, 400 MHz controller can utilize 20 GBit pro sec throughput over any kind of link aggregation. The forum is full of topics, where people complaining about the implemented SW based solutions of LAG. If not, what is the best solution to provide the highest speed possible between these 2 switches ?Ģ x direct attached cable for both SFP+ slots and building a LAG (LACP)Īggregated you will own then an 20 GBit/s uplink between this switches.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |